Mar 09, 2023 Leave a message

How to install and use the grinding wheel

1. Before installation and use, the grinding wheel must be visually inspected to see if there is crack or damage, and the sound should be clear and crisp when it is knocked with a wooden hammer. Before use, the rotary test should be carried out according to the provisions of GB/T2493 standard, otherwise, it is forbidden to use
2. Before installation, the spindle speed on the machine tool must be checked and must not exceed the working speed indicated on the grinding wheel
3. Only special nut wrench is allowed to fasten the grinding wheel, and it must be tightened symmetrically and gradually in sequence on the opposite sides of the main shaft. The nut should be properly tightened. It is forbidden to use supplementary clamps or percussion tools. Turn off the coolant to avoid imbalance of the grinding wheel
4. The fit between the grinding wheel aperture and the grinding wheel spindle and chuck shall comply with GB4674 standard
5. The newly installed grinding wheel must be idled at the working speed for the following time with a protective cover: the grinding wheel with an outer diameter of<400 mm shall not be less than 2 minutes, and the grinding wheel with an outer diameter of ≥ 400 mm shall not be less than 5 minutes. When idling, the operator shall not stand in front of the grinding wheel or in the tangent direction
6. Grinding wheels not specially used for end grinding (such as parallel grinding wheels) shall not be grinded with the end face of the grinding wheel. Grinding wheels not specially used for cylindrical grinding (such as bowl-shaped and cup-shaped grinding wheels) shall also not be grinded with the outer circle of the grinding wheel to avoid grinding wheel breakage
7. When the grinding wheel is grinding the workpiece, it is forbidden to push the workpiece with a lever to increase the pressure on the grinding wheel
8. For the thin grinding wheel and cymbal grinding wheel, if the force is too strong during cutting, it is easy to occur that the grinding wheel stops rotating, gets stuck and breaks the grinding wheel, resulting in damage to the grinding wheel. When cutting the workpiece, it is not allowed to overlap multiple pieces of workpiece to prevent accidents

 

Send Inquiry

whatsapp

Phone

E-mail

Inquiry