Mar 02, 2023 Leave a message

Overview of Fried Dough Twists drills

The diameter of Fried Dough Twists drill is limited by the hole diameter. The spiral groove makes the drill core thinner and the drill bit has low rigidity; There are only two ribbed belts to guide, and the axis of the hole is easy to deflect; The horizontal edge makes it difficult to center, the axial resistance increases, and the bit is easy to swing. Therefore, the shape and position errors of the drilled holes are large. The front and rear tool faces of the Fried Dough Twists drill are curved surfaces, and the front and rear angles along the main cutting edge are different. The front angle of the transverse edge is - 55 °. Poor cutting conditions; The distribution of cutting speed along the cutting edge is unreasonable. The cutting speed of the tool tip with the lowest strength is the highest, so the wear is serious. Therefore, the hole accuracy is low. The full cutting edge of the main cutting edge of the drill bit participates in cutting, and the cutting speed of each point on the edge is not equal, which is easy to form spiral chips and difficult to remove chips. Therefore, the chip often scratches the hole wall due to extrusion friction with the hole wall, and the surface roughness after machining is very low
The "less grinding" of Fried Dough Twists drill is first "no grinding". If you get the drill bit quickly, it must be a blind grinding. It is very important to lay a solid foundation for the next step of "grinding" only by placing the position before grinding.
The Fried Dough Twists drill shaft protrudes the sharp angle obliquely, which refers to the position relationship between the drill shaft centerline and the grinding wheel surface. The "sharp angle" is half of the top angle of 118 ° ± 2 o, which is about 60 °. This position is very important and directly affects the size of the top angle of the drill bit, the shape of the main cutting edge and the oblique angle of the transverse edge. Remind students to remember the 60 ° angle of a commonly used 30 °, 60 ° and 90 ° triangle, which is easy for students to grasp. Pithy formula 1 and pithy formula 2 refer to the relative position of the drill bit before grinding. Both should be taken into consideration. Do not neglect to set the bevel in order to set the edge flat, or to set the axis obliquely. These errors often occur in practical operation. At this time, the drill is ready to contact the grinding wheel when the position is correct. Hard quality, easy to use

 

Send Inquiry

whatsapp

Phone

E-mail

Inquiry